doi: 10.18178/ijesd.2017.8.6.985
Preparation of Anion Exchange Resin Loaded with Ferric Oxide for Arsenic (V) Removal from Aqueous Solution
- 1the Department of
- 2the Department of Chemistry and
- 3the Department of Primary Industry and
Abstract
In this study, an adsorbent (FO-Dowex) wasprepared by modification of commercial strong base anionexchange resin (Dowex marathon MSA) with ferric oxide (FO)and applied as adsorbent for removal of As(V) from aqueoussolution. The effects of initial iron concentration and reactioncontact time on adsorption capacity of As(V) were investigatedfor optimal conditions of adsorbent. In addition, the FO-Dowexwas characterized using scanning electron microscopy andFourier transformed infrared spectroscopy. It was shown thatthe optimal initial iron concentration and reaction contact timewere 0.5 mol/L and 12 h, respectively. Comparison ofadsorption performance between the prepared FO-Dowex andthe anion resin revealed that FO-Dowex exhibited higheradsorption capacity with the value of 74.07 mg/g compared tothe one from anion resin (49.75 mg/g) under the same conditions.It can be suggested that the modification of anion resin withferric oxide can significantly improve the adsorptionperformance in As(V) removal.
Keywords
- Adsorption
- arsenic
- ferric oxide
- anion exchange resin
How to Cite
tandorn.sujitra@gmail.com, Orn-Anong Arqueropanyo, Wimol Naksata, and Ponlayuth Sooksamiti, "Preparation of Anion Exchange Resin Loaded with Ferric Oxide for Arsenic (V) Removal from Aqueous Solution," International Journal of Environmental Science and Development, vol. 8, no. 6, pp. 399-403, 2017. https://doi.org/10.18178/ijesd.2017.8.6.985
Copyright & License
Copyright © 2017 by the authors. This is an open access article distributed under the Creative Commons Attribution License which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited (CC BY 4.0).
